エルドラド カジノ

次のページ 前のページ 目次へ

2. isapnp.conf の例

以下は、私の isapnp.conf ファイルのコピーです。ファイル内の コメントの多くは省略しています。

# Trying port address 0203
# Board 1 has serial identifier 67 00 00 40 17 2b 00 8c 0e

# (DEBUG)
(READPORT 0x0203)
(ISOLATE)
(IDENTIFY *)

# Card 1: (serial identifier 67 00 00 40 17 2b 00 8c 0e)
# CTL002b Serial No 16407 [checksum 67]
# Version 1.0, Vendor version 2.0
# ANSI string -->Creative SB16 PnP<--
#
# Logical device id CTL0031
#
# Edit the entries below to uncomment out the configuration required.
# Note that only the first value of any range is given, this may be changed if required
# Don't forget to uncomment the activate (ACT Y) when happy

(CONFIGURE CTL002b/16407 (LD 0
#     ANSI string -->Audio<--

# Multiple choice time, choose one only !

#     Start dependent functions: priority preferred
#       IRQ 5.
#             High true, edge sensitive interrupt (by default)
(INT 0 (IRQ 5 (MODE +E)))
(DMA 0 (CHANNEL 1))
(DMA 1 (CHANNEL 5))
(IO 0 (BASE 0x0220))
(IO 1 (BASE 0x0330))
(IO 2 (BASE 0x0388))
(ACT Y)
))

(CONFIGURE CTL002b/16407 (LD 1
(INT 0 (IRQ 11 (MODE +E)))
(IO 0 (BASE 0x01e8))
(IO 1 (BASE 0x03ee))
 (ACT Y)
))


(CONFIGURE CTL002b/16407 (LD 2
#     ANSI string -->StereoEnhance<--
#     Logical device decodes 16 bit IO address lines
#         Minimum IO base address 0x0100
#         Maximum IO base address 0x0138
#         IO base alignment 8 bytes
#         Number of IO addresses required: 1
#(IO 0 (BASE 0x0100))
#(ACT Y)
))


(CONFIGURE CTL002b/16407 (LD 3
(IO 0 (BASE 0x0200))
(ACT Y)))


次のページ 前のページ 目次へ